For Cubot KingKong Star Original LCD Display Rear Screen Digitizer Assembly, For Cubot KingKong Star(Original)

Product information
1. Replacement part for rear LCD screen.
2. This part is used to replace the damaged or non-working one with a new one.
3. Each item has been checked and is in good condition before shipping.
4. Fully suitable and functional.
5. Installation of any new parts must be done by a qualified person. We will not be responsible for any damage caused during installation.
Notes before installation
1. Tips 1: Test before installation
During testing, do not remove any protective film or label. Pay attention to the problem of static electricity.
Before attempting any repairs, be sure to ground yourself with an ESD (electrostatic discharge) strap. This will prevent static electricity from damaging the electronic components inside your phone.
Be sure to wear eye protection and be careful not to cut your fingers on flying glass.
2. Tips 2: Simulate the test
Screen replacement is a very fragile product. It is strongly recommended to test before installation. Please simulate testing, that is, mobile phone apart, (motherboard + LCD or screen) connected audio cable and new replacement, power on, test finished. If the test is OK, install it. If it does not display, contact us at the first time. And please do not force installation in the mobile phone. We will not be responsible once the screen is installed.
3. Tips 3: Do not bend the cable excessively
Make sure the LCD cable is not bent excessively. Bending more than 90 degrees will cause a black display.