Delay Timer Relay Control Switch Module Timer Delay Automation Cycle LED Display MOS DC 5-30V

Product information
1. Multi-function timing relay module, 5~30V wide voltage power supply, MOS tube control output, no contact, no ignition, little interference.
2. Control capacity up to 10A.
3. Up to 31 working modes are available to meet various automatic testing and control applications.
4. The delay time is adjustable from 0.01 seconds to 999 minutes.
5. The trigger port can be activated by a voltage signal or by connecting a button.
Specifications
1. Power supply voltage: 5~30V
2. Trigger terminal voltage: DC 3.3~30V (can also be triggered by button)
3. Control current: 10A
4. Module size: 63 x 42 x 14mm (length, width and height)
Using Tips
1. Setting working parameters: Press and hold S1 button without letting go, the display will show P-xx after 0.5 seconds, press S2 and S3 to switch working mode.
2. After selecting the working mode, short press S1 button to enter the A time setting, and the screen displays Axxx. At this time, press S2 and S3 buttons to change the A time parameter. Short press S2 and S3 buttons to add or subtract 1, and long press to quickly add or subtract 10.
3. Press S4 button to set the decimal point position. After setting time A, press S1 button to set time B and the screen displays bxxx. At this time, press S2 and S3 buttons to change the time parameter B.
4. Short press S2 and S3 keys to add or subtract 1, long press to quickly add or subtract 10. Press S4 key to set the decimal point position. After setting B time, press S1 key to set C time, the screen displays Cxxx, then press S2 and S3 keys to change the parameter of c time, short press S2 and S3 keys to add or subtract 1, long press to quickly add or subtract 10, press S4 key to set the decimal point position.
5. After setting the time c, press the S1 button to enter the maximum setting of parameter d. Parameter d is the numeric parameter, ranging from 1 to 999. After setting the parameter d, press the S1 button one last time to exit the setting state and save all the parameters.
Point position
1. Ax.xx The decimal point is in hundreds and the time range is 0.01~9.99 seconds
2. Axx.x The decimal point is in place of the tens and the time range is 0.1~99.9 seconds
3. Axxx. The decimal point is in place of the units and the time range is between 1 and 999 seconds
4. Axxx has no decimal point and the time range is 1~999 minutes
5. Display off: In the unset state, press S4 button to turn off the display, then press it to turn it on again.